It's time to install your LED wall washers now that you've chosen and purchased them. I've included four simple instructions below that will help you install the LED washer as quickly as possible:
1. Ensure Safety
Make sure everyone is safe before you install wall washers. Use rubber shoes and hand gloves to avoid electric shocks while doing this.
2. Measure The lighting Area
The installation area has to be measured and taped off next. To connect the lights to the power supply, work on the wiring now.
3. Installation and Connection
After finishing up with the wirings, drill where the tape has been indicated. To establish the base of the wall washer lights, drill holes with a diameter of half an inch. Place the light fixtures inside after firmly screwing them into the wall. Run the cables through the lights at this time. Connect the cords to the power supply after mounting the LED wall washer.
4. Final Check
To see whether the wall washers are glowing, turn on the switches. If not, disconnect the power supply, inspect the wiring, and then reconnect.
