LED Outdoor Floodlight Projection

Premium High-Density LED Light Source & Service Life Performance

• Adopts high-brightness 2835 SMD integrated LED lamp beads, ultra-high light transmittance transparent PC lampshade, uniform light output without dark spots or glare, luminous efficiency up to 120LM/W, far brighter than ordinary solar flood lights of the same power.

• Long service life design: Each LED chip undergoes strict anti-corrosion and aging treatment, stable light decay control, lumen maintenance rate remains above 85% after 50,000 hours of continuous operation.

• Low light loss & low attenuation: The transparent anti-yellowing lampshade effectively avoids light loss caused by dust accumulation and UV aging; constant current drive circuit suppresses chip overheating light decay, light attenuation rate less than 3% within the first 3 years of use, far lower than market average products.

• Anti-corrosion optical structure: The sealed lamp cavity prevents rainwater, dust and acid fog from eroding LED chips, eliminates chip short-circuit and dead light risks, greatly extending the overall lamp service life.

Efficient Die-Cast Aluminum Heat Dissipation System & Loss Control

• Full die-cast aluminum rear heat sink with vertical ribbed heat dissipation structure, large heat exchange contact area, rapidly conducts heat generated by LED chips during operation to the outer shell.

• Rapid air convection cooling design accelerates heat exchange between the lamp body and surrounding air, effectively lower the working temperature of LED chips and built-in lithium battery.

• Low energy loss: Excellent heat dissipation avoids excessive thermal loss of light energy, converts more electric energy into visible light instead of waste heat, improves overall energy utilization efficiency by over 18%.

• Overheat protection loss reduction: High thermal conductivity aluminum material prevents overheating damage to chips and battery, cutting down replacement and maintenance loss caused by thermal burnout, reducing long-term operation cost for buyers.

• Integrated heat sink and lamp housing one-piece molding, no loose heat conduction gaps, zero heat transfer loss, stable constant temperature working environment for internal electronic components.

IP66 Industrial-Grade All-Weather Protection Grade Performance

• Official IP66 full protection rating, fully enclosed integrated sealing structure, reaching engineering industrial waterproof standard.

• Dust-proof Grade 6: Completely dust-tight structure, no fine dust can penetrate into the lamp interior, avoids dust blockage causing light loss and circuit short circuit.

• Water-proof Grade 6: Powerful anti-splash & heavy rain resistance, can withstand direct high-pressure water jet flushing from any angle, works stably in heavy rain, snow, fog and humid coastal environments.

• Multi-layer sealing waterproof process: Silicone rubber waterproof ring + fully covered sealant, anti-corrosion, anti-oxidation, anti-moisture, internal battery and circuit board will not be damaged by dampness.

• Lightning & thunder protection design: Built-in surge protection module, effectively resist instantaneous voltage surge caused by thunderstorm weather, prevent circuit breakdown loss under extreme weather.

• Wide temperature adaptive protection: Stable operation from -30℃ to +60℃, no performance degradation in high-temperature summer or freezing winter, suitable for global all-climate regions.