How to use led wall washer?
1. Get ready
(1) Place the tin bar and soldering iron required for the LED lamp bead before mounting the LED wall washer.
On the aluminium substrate, welded, and prepared for use during installation.
(2) First, inspect the installation supplies; if there are any issues, you may arrange for a refund or an exchange.
Installing the toolkit is now ready.
2. Check
Check the soldered board once again to make sure the installation was done correctly, and see whether the power-on test
In order to prevent the circumstance where it does not light up after the soldering is finished and needs to be disconnected and reconnected, it is typically bright.
3. If the lamps can be lighted properly, cover the aluminium substrate's back with a layer of heat-dissipating silica gel first.
Place the board inside the casing after that.
4. Welding
(1) Attach the power cord to the aluminium substrate's positive and negative poles using welding, then tape the ends together.
The glue needs to be securely attached.
(2) The general level throughout the glue filling process should be equal and flat; slanting or slanting will impact the final product.
impact of installation.
5. If you use adhesive, remove the leftover account in the afternoon of the same day before placing the glass.
Glass, after which plug the two wall washer installation ends.
6. After installing the male and female connectors, wire the wall washer light in accordance with the parameter control handbook. Pay close attention to the outlet interface to avoid making a mistake.
7. Power up the machine before turning on the switch to see if the completed product is ordinarily bright. If not, retest the adjustment.
